VOLVO Engine Valve, Valve Seat Grinding Guide

  VOLVO MD2010, MD2020, MD2030, MD2040 Engine  Grinding of valves and valve seats

1. Use a valve spring tensioner and dismantle    the
   valve lock. Remove the valve spring    washers,
   springs and aloes. Place the parts in the    correct
   order in a valve rack. Remove the valve    stem seals.
2. Clean the part
Volvo Vodia Penta 2018 [5.2.5] Diagnostic Software

3. Check the wear on the valve spindle.    Measure the
   diameter with a micrometer at points I, II    and III as
   per Fig. 18.

VOLVO PROSIS Offline Parts Catalog & Repair Manuals 11.2022

 4. Grind the valves in a valve grinding    machine
   Grind the sealing surface as little as    possible, just
  so that it is "clean". If the the valve disc   edge after
  grinding is less than 0.5 mm (.019 in) the   valve
  should be scrapped (see Fig. 19). The same   applies to valves with crooked valve   spindles

5. Check the wear on the valve guides (see "Checki ng of valve guides") before the valve seats are
treated.

6. Ream or grind the valve seats (Fig. 20). Grind of
j ust enough material so that the valve seat has the
right shape and a good mating surface.

Replace the valve seat when the distance "A" in Fig. 21,
measured with a new valve, exceeds 1.8 mm (.0708 in).
For replacement of the valve seat (inlet) see previous
page.
New seats are grind down so that the distance between the cylinder head plane and the valve disc
surface "A" is:
MD2O10, MD2020: 0.70-0.90 mm (.0275-.0354 in)
MD2030, MD2040 : 0.85-1.15 mm (.0334-.0452 in)

11.2021 Volvo Impact 9227 EPC+ Service Repair Offline Download

7. Grind in the valves with grinding paste and check
the contact with marker dye

8. Fit the seals, valves, valve springs, spring washers,
valve lock and valve caps. See "Assembly of cylinder head" on page 31.